SENA Rhio232 - Manual (Page 15)

15
Figure 2.8 Quick connect dialog box
2.4 Restoring Factory Default
Users may restore the Rhio232 parameters into factory default value by pressing factory reset
switch on the hole of the Rhio232 side panel. They will have to put the sharp pin into the hole
and press it for around 1 sec to reset the Rhio232. The Rhio232 will be rebooted after the
operation.
The following is the factory default value of the parameters.
I/O Port status: Enable
ADC Operation mode : Level Mode
Power-out Post Recovery: Enable
ADC Threshold value : 512
Output Port operation condition : None
Run/Stop status : Run