SENA Rhio232 - Manual (Page 28)

28
RHIO_SndCmd_GetPortEnable
Send a command that checks enable/disable
state of all ports.
RHIO_SndCmd_SetPwrStopEnable
Send a command that enables/disables
power-out recovery for all ports.
RHIO_SndCmd_GetPwrStopEnable
Send a command that checks enable/disable
state of power-out recovery for all input ports.
RHIO_SndCmd_SetFactoryReset Send Rhio Factory Reset command.
RHIO_SndCmd_SetSerial Send a command that sets Rhio serial number.
RHIO_SndCmd_GetSerial
Send a command that checks Rhio serial
number.
RHIO_SndCmd_GetFirmware
Send a command that checks Rhio Firmware
version.
RHIO_GetSettingData
Retrieve corresponding data when an event
occurs such that a response on a check for
setting is received from each port.
RHIO_GetOnOffData
Retrieve corresponding data when an event
occurs such that responses from a change in
and control of ON/OFF setting are received.