SENA Parani-SD200L User Manual
Parani-sd200l user guide
Advertising
Table of contents
Document Outline
- 1. Introduction
- 2. Getting Started
- 3. Configuration
- 4. Approval Information
- 5. RF Information
- Appendix A: Connections
- Appendix B: AT Commands
- Appendix C: S-Register
- C.1. S1: Force to Reconnect (default 1)
- C.2. S3: Stream UART Policy (default 0)
- C.3. S4: Enable Remote Name Query (default 1)
- C.4. S6: Enable Low Power Mode (default 0)
- C.5. S10: Enable Response Message (default 1)
- C.6. S11: Enable Escape (default 1)
- C.7. S12: Clear Data Buffer When Disconnected (default 0)
- C.8. S13: Enable DCD Signal (default 1)
- C.9. S14: Enable DTR Transfer (default 1)
- C.10. S15: Enable Disconnect by DTR (default 0)
- C.11. S22: Faster Connection (default 0)
- C.12. S24: Maximum Number of Inquiry Result (default 10)
- C.13. S28: Escape Sequence Character (default 43)
- C.14. S31: Page Timeout (default 300)
- C.15. S33: Inquiry Timeout (default 30)
- C.16. S37: Supervision Timeout (default 16000)
- C.17. S46: BD Address of Last Connected Device
- Appendix D: Trouble Shooting
- Appendix E: SD200L mechanical drawing
- Appendix F: Warranty