SENA Parani-SD200L - Manual (Page 31)

31
B.3.5. AT+USEDIP?

SD Response m
Purpose Check the Baud rate set by the dip switch
Description m=0: Dip switches are set to ‘S/W Config’
m=1: Please view the dipswitches to view your baud rate.
Reference AT, ATZ, AT&F, ATS
B.3.6. AT+BTINFO?

SD Response 112233445566,DeviceName,Mode,Status,Auth,Encryp,FlowControl
OK
Purpose Display Bluetooth settings
Description The current Bluetooth settings are displayed including BD address, Device name,
Operation mode, Operation status, Authentication, Data Encryption, and Hardware Flow
Control. The initial value of Device name is ‘PSD200Lv1.0.0-445566’. PSD200L stands for
Parani-SD200L, v1.0.0 for the version of firmware, and 445566 for the last 6 digits of BD
address.
Mode=MODE0/MODE1/MODE2/MODE3
Status=STANDBY/PENDING/CONNECT
Auth=0/1 (Authentication is not activated when 0)
Encrypt=0/1 (Encryption is not activated when 0)
FlowControl=HWFC/NoFC
Reference AT+BTNAME, AT+BTMODE, AT+BTSEC, ATS14?
B.3.7. AT+BTINQ?

SD Response 112233445566,FriendlyName,CoD
112233445566,FriendlyName,CoD
112233445566,FriendlyName,CoD
OK
Purpose Search Bluetooth devices nearby
Description The Bluetooth devices in Inquiry scan mode nearby are displayed with their BD addresses,
Device names, and Class of device.
Maximum 15 devices are scanned for 30 seconds. (Default 10 value in S-register 6)
Reference AT+BTSCAN, ATD, AT+BTINFO?
B.3.8. AT+BTLAST?

SD Response 112233445566
Purpose Display the BD address of the last connected device
Description The Bluetooth device last connected to this Parani-SD200L is displayed with its BD
address.
Reference AT+BTSCAN, ATD, AT+BTINFO?, AT+BTINQ?