SENA Parani-SD200L - Manual (Page 18)

18
Figure 3-6 Device Setting Window
Parani-SD200L supports two security options, Authentication and Encryption. If you enable the
Authentication option, you must also enter a Pin Code value. If the authentication is enabled, the
connection, between the Master and Slave device must share the same Pin Code. In case that Parani -
SD200L connects to another Bluetooth device, that requires authentication, you must know the other
device’s Pin Code. In general, most Bluetooth devices have a pincode of 1234 or 0000. If you check
Encryption option, the Parani-SD200L will encrypt packets and sent to the device. The Encryption
options works well in case that only one of the devices between Master and Slave use the Encryption
option.
Parani-SD200L has 4 response messages, ‘OK’, ‘ERROR’, ‘CONNECT’, and ‘DISCONNECT’. In
some cases, these responses can affect the host system unexpectedly. To prevent this, user can set
the Command response to ON or OFF.
For Parani-SD200L, hardware flow control can be configured only by dip switch. Thus H/W Flow
Control option will not work in this case. When the dipswitch value isn’t ATcommand mode, the Baud
Rate menu will be disabled.
Click [Apply] button to apply any changes made to the Parani -SD200L.
Connection(out) icon will show the following window to search and connect other Bluetooth devices.