SENA Parani-SD200L - Manual (Page 22)

22
In this example we will refer to the two Parani-SDs as SD1 and SD2 respectively. To use this menu,
please do the following:
Step 1. Connect the first SD and then push the START button.
Step 2. Disconnect the first SD, connect the second SD and then push the Next button after setting up
Slave configuration. At this time, the dip switch value should be ATcmd mode. The flow control
setting can be changed only through dip switch.
Step 3. Disconnect the second SD, once again connect the first SD and then push the Finish button.
The pairing configuration should be completed. Make sure that each SD’s connect LED is on. At this
point, when both SD’s restart the connection will be established automatically.
3.11 ParaniUpdater
Parani-SD200L supports firmware updates. You can download new firmware images for the Parani-
SD200L at http://www.sena.com. With the ParaniUpdater, you can update the firmware of Parani-
SD200L by selecting the firmware image file and pushing Start button.
* Note: DO NOT power off Parani-SD200L while the firmware update is progressing, this may damage
the Parani-SD200L.
Figure 3-11 ParaniUpdater Window
3.12 Terminal Program
A terminal program is typically an application that will enable a PC to communicate directly with a
modem. If you are using Windows 98SE or higher version of Windows, HyperTerminal program is
included as part of the operating system. Parani-SD200L provides some extended AT commands for
configuration of the Parani-SD200L.
This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click
start>setting>control panel>add/remove programs. For more precise details on HyperTerminal
installations, please refer to Microsoft Windows Help section.
.