SENA Parani-SD200L - Manual (Page 10)

10
2. Getting Started
This chapter describes how to set up the Parani-SD200L for the first time.
- 2.1 Panel Layout explains the panel layout.
- 2.2 Connecting the Hardware describes how to connect the power, the serial device to the Parani-
SD200L.
Following items are required to get started:
- One DC power adapter, USB power cable or DC power cable (included in the package).
- One PC with RS232 serial port.
- Terminal emulation program running on the PC
2.1. Panel Layout
This section describes the panel layout of the Parani-SD200L.
Figure 2-1 The panel layout of Parani-SD200L
2.2. Connecting the Hardware
This section describes how to connect the Parani-SD200L to the serial device.
- Connect a power source to the Parani-SD200L.
- Connect the Parani-SD200L to a serial device.
2.2.1. Connecting Power to Parani-SD200L
Connect the power jack to the power connector of the Parani-SD200L using the DC power adapter,