SENA Parani-SD200L - Manual (Page 33)

33
The parameter nn must be a printable character.
Reference +++, ATO
Example AT+SETESC,42
B.3.13. ATO

SD Response None
Purpose Convert the operation status of ‘Standby’to ‘Connect’
Description You can convert the operation status of ‘Standby’to ‘Connect’ready to transmit data.
Reference +++, AT+SETESC
B.3.14. AT+BTCANCEL

SD Response OK
Purpose Terminate the current task
Description This terminates a current executing task, such as Inquiry scan and Page scan, then
converts the operation status to ‘Standby’
Reference AT+BTSCAN, ATD, AT+BTINQ?
B.3.15. AT+BTSCAN

SD Response OK
CONNECT 112233445566
Purpose Wait for inquiry and connection from other Bluetooth devices
Description This allows the inquiry and connection from the other Bluetooth devices. The operation
status will be in ‘Pending’after this command. When connection is made and released, the
operation status is back set to ‘Pending’. To convert the operation status to ‘Standby’
AT+BTCANCEL must be used.
This has the same effect as AT+BTSCAN,3,0.
When a connection is made with another Bluetooth device, SD response will be
‘CONNECT’with its BD address.
Reference ATD, AT+BTINQ?, AT+BTCANCEL
B.3.16. AT+BTSCAN,n,to

SD Response OK
CONNECT 112233445566
or
OK
ERROR
Purpose Wait for inquiry and connection from other Bluetooth devices for a given duration
Parameters n=1: Allows Inquiry scan
n=2: Allows Page scan
n=3: Allows both of Inquiry scan and Page scan