SENA Parani-MSP1000 - Manual (Page 12)

12
2.3. Connecting the Hardware
This section describes how to connect the Parani-MSP1000 to your equipment for initial
testing/installation.
- Connect the power source to the Parani-MSP1000
- Connect the Parani-MSP1000 to a Ethernet network.
2.3.1. Connecting the power
Connect the power cable to the Parani-MSP1000. If the power is properly supplied, the [Power] lamp
will light up solid green.
Figure 2-2 Connecting the power to the Parani-MSP1000
2.3.2. Connecting to the network
Plug one end of the Ethernet cable to the Parani-MSP1000 [Eth0] port. The other end of the Ethernet
cable should be connected to an Ethernet network. If the cable is properly connected, the Parani-
MSP1000 will have a valid connection to the Ethernet network. This will be indicated by:
The [Eth0] LED flashing to indicate incoming/outgoing Ethernet packets.