SENA Parani-MSP1000 - Manual (Page 36)

36
Figure 5-2 Port configuration
5.5.1. Port pairing mode (Custom mode only)
If the mode is “Acceptor”, the Parani-MSP1000 waits for incoming connection from the Bluetooth
device. If the mode is “Connector”, the Parani-MSP1000 attempts to connect the Bluetooth device.
5.5.2. Service category - CLI
When a new connection is created, the Parani-MSP1000 provides a CLI for the connection. With this
option, system administrators are able to access to CLI without the use of a serial cable.
Figure 5-3 Service category - CLI
5.5.3. Service category - Network
When a new Bluetooth connection is created, the Parani-MSP1000 starts the registered network
service. If the network service is client, the Parani-MSP1000 creates an outgoing connection and if the
network service is server, the Parani-MSP1000 listen on a TCP port. And then, if TCP connection is
established, the data received from SPP is transmitted to TCP/IP and the data received from TCP/IP is
transmitted to SPP. If there are more than one registered network service, each network service
operates independently.