GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 15)

GEH-6412 Toolbox for AV-300i Version 2 Drive Chapter 2 Installation •••• 2-1
Chapter 2 Installation
Introduction
This chapter describes the PC and installation requirements for the products in
Control System Solutions. The contents of this CD depend on the products that are
ordered. Some orders are issued a License Key. Available products display in the
Product Selection dialog box (see the section, Product Selection).
Section Page
Computer Requirements...................................................................................... 2-1
Installing Control System Solutions..................................................................... 2-2
Registration License Agreement ................................................................... 2-2
Destination Directory ................................................................................... 2-3
Product Selection ......................................................................................... 2-3
Uninstall Products ........................................................................................ 2-4
Computer Requirements
The minimum PC requirements are determined by the selected product combination
and the topology configuration of the PC(s). The minimum requirements to use the
Control System Solutions products are as follows:
• 100 MHz processor (Pentium 166 or higher recommended)
A cursor-positioning device is
highly recommended. • Microsoft ® Windows ® 95 or Windows NT ® 4.0
• VGA display (640 x 480 x 16 color or gray scale)
• 16 MB RAM in Windows 95 (32 MB recommended) or 24 MB RAM in
Windows NT (32 MB recommended)
• Serial port for direct connection to a drive
• Printer (with appropriate Windows driver installed)