GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 28)

3-10 •••• Chapter 3 Using the Toolbox GEH-6412 Toolbox for AV-300i Version 2 Drive
Trend Recorder
The Trend Recorder tab allows you to choose specific options as follows:
Check Horizontal Grid
Lines to display horizontal
grid lines when in Replay
mode.
Check Vertical Grid
Lines to display vertical
grid lines in Replay mode.
Check Right Vertical Axis
to display vertical axis on
the right-hand side of the
Trend Recorder.
Check to automatically
configure the Trend
Recorder with predefined
signals. (This feature
currently only works with
Innovation Series drives
and when performing
MarkVI I/O board
calibrations.)
Check to zoom in the
Trend Recorder, using the
mouse to drag-and drop a
rectangle on the screen.
Check for a Yes/No
confirmation prompt to
display before the zoom
takes place.
Select the font size used in
the upper window of the
Trend Recorder.
Select the default
pen width
(measured in pixels)
used to draw the
signal traces. This sets the amount of memory
the toolbox reserves for storing
traces. The default value of 2 MB
allows 4 signals to be captured at
32 ms intervals for about 14
minutes before the oldest data
starts to be overwritten.
Signal List Font sets the font
type and size used in the lower
window of the Trend Recorder.
Check to display
the amount of
reserved memory
that was used.