GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 53)

GEH-6412 Toolbox for AV-300i Version 2 Drive Chapter 4 Configuring an AV-300i Version 2 Drive •••• 4-23
Drive Controls
The Drive Control command enables you to operate the drive from the toolbox, as
though you were operating it directly from the keypad located on the cabinet door.
The variables that display are the same as those that display on the keypad.
Or click
Ш Ш Ш Ш To display the Drive Control view
w From the View menu, select Drive Control. The Drive Control view
displays.
Click to toggle the
direction of the drive
(reverse resquest). The
selected direction is shown
with an icon or .
Click to reset faults.
Click to Run the drive in
the selected direction.
Stop command can be
used in Local or Remote
mode.
Click to decrease or increase the Local Speed Reference
associated with the Run and Stop commands.
Click to Jog the drive in
the selected direction.
Wizards
The Wizard list may vary with
each product, but there is
always an Offline Basic
Commissioning Wizard.
Or click
The AV-300i Version 2 drive contains wizards that guide you through the setup of a
drive. Wizards display a series of dialog boxes that prompt you for drive
configuration information. This information is also used as a basis to perform
additional tests and tune-ups on the drive.
Note Proceeding through the Offline Basic Commissioning Wizard or the Offline
Advanced Commissioning Wizard should be the first step when setting up a new
drive.
Ш Ш Ш Ш To perform a wizard
w From the Edit menu, select Wizards.
If more than one wizard is defined, the Choose Wizard dialog displays
listing the available wizards. However, if only one wizard is defined, the initial
Offline Wizard dialog box displays immediately.