GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 46)

4-16 •••• Chapter 4 Configuring an AV-300i Version 2 Drive GEH-6412 Toolbox for AV-300i Version 2 Drive
Configuration
Parameters
For detailed information
about a parameter, click on
the parameter and press F1. The drive contains a set of parameters with values, together with the pattern and
version, that define the drive behavior. In the Outline View of the toolbox,
parameters display as follows:
Editing Parameters
Use the Finder to easily
locate a specific parameter.
Or click the right mouse
button and select Modify.
Ш Ш Ш Ш To modify a parameter
1. From the Outline View, click on the parameter to modify.
2. From the Edit menu, select Modify. The Edit Parameter dialog box displays.
This function is currently
not available.
Click to display the
detailed Help for this
parameter.
Click to send the new
value to the drive.
This button may not be
enabled for all parameters.
It allows you to change the
display units (only effects
the displayed values and
not the drive control.)
The new value displays
under Drive Value.
Enter a new value (within the range) or, depending on the item, select a value
from the drop-down menu. Then, click Send To Drive for the value to take effect.
Enter a note for this
parameter, if desired.
Note When a parameter value is edited, you must click Send To Drive for the value
to take effect. Also, remember to permanently save the parameter, select the Device
menu and then select Save Parameters.