Options menu – GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive User Manual
Page 43
GEH-6412 Toolbox for AV-300i Version 2 Drive
Chapter 4 Configuring an AV-300i Version 2 Drive
••••
4-13
Or click
Upload Parameter Values from Drive reads all the parameter values from the
current drive and replaces the values in the currently loaded drive configuration file
in the toolbox.
This option enabled only if
you are at Privilege Level 4
and in Expert Mode.
Download Firmware to Drive sends the drive firmware configuration to the
selected version number.
Save Parameters saves the current active set of parameter values in the drive to
permanent storage
Reset Faults resets all faults that are currently active in the drive.
Genius Interface allows you to upload and download the Genius Network card if
enabled.
This option enabled only if a
network is enabled.
Put into Database puts information into the Innovation Series Controller SDB to
allow drives to share signals with other drives and controllers on the network.
Change Drive Size allows you to change the drive size information in the file,
drive, or both.
This option requires the drive
to be online and not enabled.
This option requires the drive
to be online and not enabled.
Load Default Values loads the factory defaults in the drive and the currently
loaded drive configuration file in the toolbox.
Load Motor Parameters loads the motor defaults for the 400 V or 460 V motor
parameters in the drive and the currently loaded drive configuration file in the
toolbox.
Self-tune allows you to activate the self-tune process where the drive and the motor
perform predefined tests on either the Current Regulator or the Speed
Regulator to determine the best running conditions for the system.
Options Menu
The Options menu allows you to manage general options for toolbox operation.
Settings allows you to set general toolbox options.
Privilege sets the privilege level for a session.
Passwords sets the password for a privilege level.
Logout User closes the current user from the current session and sets the privilege
level back to 0.