GE Industrial Solutions Control System Toolbox For an AV-300i Version 2 Drive - Manual (Page 35)

GEH-6412 Toolbox for AV-300i Version 2 Drive Chapter 4 Configuring an AV-300i Version 2 Drive •••• 4-5
Validating the Drive
Also, items in the hierarchy
that had problems during
validation will display in red
after the validation. Validation checks for errors that might prevent successful operation of the drive. If
the configuration needs to be validated, items in the Outline View display in red.
Note In most cases, the configuration is automatically validated.
Or click
Ш Ш Ш Ш To validate the drive configuration
wwww From the Drive menu, select Validate. The validation results display in the
Log View at the bottom of the toolbox Work Area screen.
Entering Job-Specific Information
For more information, refer
to the section, Wizards. Once a new drive has been created and the properties are modified, you must enter
job-specific data, such as motor hp, motor amps, and motor speed. This information
can be entered in a new configuration using the menus or the Offline commissioning
wizard.
Or click
Ш Ш Ш Ш To configure the drive offline
1. From the Edit menu, select Wizards.
If more than one wizard is defined, the Choose Wizard dialog box displays.
Select Offline Basic Commissioning Wizard. However, if only one wizard
is defined, the Offline Wizard dialog box will display immediately.
Each configuration depends on application
requirements. For more information, contact Product
Service Engineering (see Chapter 2 for the contact
information).
For more information, see the
section, Wizards. 2. Click Next to progress through the wizard. Enter the appropriate settings .
Note By entering the Offline Basic Commissioning Wizard information and
performing the applicable tune-ups, the drive should be sufficiently configured for
basic operation.