GE Industrial Solutions GE ZENITH SERIES MDU User Manual
Page 32
System Monitoring
GE Z
ENITH
C
ONTROLS
MDU Owner’s Manual
601 S
HILOH
R
OAD
January 2013
Plano, TX 75074
Page 32
2. SNMP
a. Hardware
The GE Zenith Series Monitor has an expansion board that can be used to provide
SNMP. The expansion board plugs into the main display board. The SNMP parameters
are configured in the setup menu on the third page. See the setup menu for more
information about configuring the SNMP. SNMP version 1 is supported.
b. Prerequisites
Each connected monitor must have a unique address. The Setup screen is used to set
up the address of the monitor.
Note: improper configuration of a GE Zenith Series Monitor may conflict with
other monitors or devices on the network.
c. Wiring
The connection to the SNMP expansion board is made with a standard Ethernet cable.
d. Supported Commands
Note that these are typical for the product. See the mib file associated with your MDU
configuration for specifics
.
a. snmpget
b. snmp
c. write single register