GE Industrial Solutions GE ZENITH SERIES MDU - Manual (Page 6)

Receiving Your MDU
GE Z ENITH C ONTROLS
MDU Owner’s Manual
601 S HILOH R OAD January 2013
Plano, TX 75074 Page 6
2.2. Inspection Procedures
The following inspection procedures should be performed immediately after your unit has arrived.
Report any damages immediately to your GE Service Team by calling (800) 637-1738. All freight
damage claims should be initiated with the freight carrier immediately.
1. C ABINET : Inspect packaging, exterior panels, and doors for any visible damage (i.e. scratches
dents, cracks, or torn packaging). If any damage is noted, please the GE Service Team at (800)
637-1738.
2. T RANSFORMER : Inspect the transformer for any loose connections or displacement during
shipment. Check to make sure all terminal lugs are tight and secure.
3. I NTERNAL FEEDERS : Ensure all lug connections are tight and secure.
 Check the main input feeder connections at the main breaker to be sure vibration has not
loosened the terminal screws.
 Using the same procedure, check the feeders from the load side of the main breaker to
the primary side of the transformer.
 Check all other lugs (i.e. neutral bus, ground bus, terminal blocks, etc.).
4. O UTPUT D ISTRIBUTION C ABLE A SSEMBLIES : cable coils must be inspected for cuts and/or damaged
conduits. Each cable should be uncoiled and inspected individually.
Note: Do not remove the cable shipping pallet until the unit is near its final position
5. I NPUT P OWER J UNCTION B OX (P OWER J-B OX ): carefully inspect the entire box for damage.