CEMB USA N300 - Manual (Page 23)

Setup function 4 - 3
Time
Time must be entered in the N300 instrument using two figures for the hours (from 00
to 23) and two for the minutes (from 00 to 59). To assist the operator, the hh:mm
format is displayed below the current time.
New values can be entered following the same procedure as that described above for
the sensitivity of the sensors (see above).
Units of measurement system
The units of measurement used for acceleration, velocity and movement values can be
respectively:
- g; mm/s; µm : metric units
- g; inch/s; mils : imperial units
After pressing the
key, you can scroll through all of the possibilities using
the and arrows.
Display brightness
The brightness of the display can be adjusted to provide excellent visibility in various
environmental conditions, from minimum (no backlighting) to maximum. This is
possible using the
and arrows after having enabled the “enter values”
mode by pressing .
Backlighting auto-off time
To extend the duration of the battery before it needs recharging, the display
backlighting turns off automatically after a preset amount of time (settable from 1 to
255 seconds) has passed since the last key was pressed. Pressing any key reactivates the
backlighting.
Instrument auto-off time
To extend the duration of the battery before it needs recharging, the instrument turns
off automatically after a preset amount of time (settable from 5 to 60 minutes) has
passed since the last key was pressed. To use the instrument again, turn it on by
pressing