CEMB USA N300 - Manual (Page 46)

7 - 2 CEMB N-Pro program (optional)
Note:
In the event of installation in a Windows Vista and Windows 7 operating system,
the following operations must be completed before the software can be used:
-
right-click on the CEMB N-Pro program icon on the desktop
- select the 'Compatibility' menu
- enable the option 'Execute program in operating mode for:' and choose
'Windows XP (Service Pack 2)'
- enable the option 'Execute program as administrator'
- press OK
Installation of drivers for USB communication with the N100
and N300 instruments
Do not connect the N instrument to the PC using the USB cable supplied until the CEMB
N-Pro software has been correctly installed; after a few seconds the following message will
appear:
-
New hardware found
-
USB <-> Serial
in the Windows application bar (lower right hand corner).
The add new hardware window will then appear with the guided procedure.
When requested to authorise Windows to connect to Internet to search for the drivers,
select the option ‘No, not this time’ and press ‘Next >’.
- Then select ‘Install from a specific location (Advanced)’ and press ‘Next >’
again.