Burkert Type 8712 - Manual (Page 5)

5
Intendeduse
Type 8626, 8712
2. inTenDeD use
nonconforming use of the mfm / mfc types 8006,
8702 / 8626, 8712 may pose a danger to people, nearby
equipment and the environment.
• Mass flow meter types 8006, 8702 are designed exclusively for
measuring the mass flow-rate of clean, dry gases.
• Mass flow controller types 8626, 8712 are designed for
controlling the mass flow-rate of clean, dry gases.
• Only use the fluids stated on the name plate and the calibration
protocol.
• Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of the
climatic conditions.
• This device must be used in compliance with the specifications
and commissioning and use conditions specified in the
contractual documents and in the user manual.
• Requirements for the safe and proper operation of the device
are proper transport, storage and installation, as well as careful
operation and maintenance.
• Only use the device as intended.
• Observe any existing restrictions when the device is exported.
3. bAsic sAfeTy
insTrucTions
These safety instructions do not take into account:
• any contingencies or occurrences that may arise during
installation, use and maintenance of the devices.
• the local safety regulations, which the operating company is
responsible for ensuring the staff in charge of installation and
maintenance adhere to.
Danger from the heated surfaces when used for prolonged
periods.
• The device must be kept away from any highly flammable
materials or fluids.
• Wear protective gloves to handle the device.
Danger due to high pressure in the installation.
• Shut off the gas flow, relief the pressure and drain the pipe
before loosening the process connections.
Danger due to electrical voltage.
• Shut down and isolate the electrical power supply before
carrying out work on the system.
• Observe all applicable accident protection and safety
regulations for electrical equipment.
English