Burkert Type 8025 - Manual (Page 21)

21
Installation
Type 8025 / 8035
7. insTAllATion
7.1. safety instructions
danger
risk of injury due to electrical voltage.
• Shut down the electrical power source of all the conductors and isolate it before carrying out work on the system.
• Observe all applicable accident protection and safety regulations for electrical equipment.
Warning
risk of injury due to nonconforming installation.
• The electrical and fluid installation can only be carried out by qualified and skilled staff with the appropriate tools.
• Install appropriate safety devices (correctly rated fuse and/or circuit-breaker); for the versions with 115/230 V AC power
supply, insert a protection device between phase and neutral.
• Respect standard NF C 15-100 / IEC 60364.
• Observe mounting instructions of the fitting.
risk of injury due to unintentional switch on of power supply or uncontrolled restarting of the installation.
• Take appropriate measures to avoid unintentional activation of the installation.
• Guarantee a set or controlled restarting of the process subsequent to any intervention on the device.
Warning
risk of injury if the fluid pressure/temperature dependency is not respected.
• Take account of fluid temperature-pressure dependency according to the nature of the materials the fitting is made of
(see the technical data and the operating instructions of the fitting used).
• Comply with the Pressure Directive 97/23/CE.
protect this device against electromagnetic interference, ultraviolet rays and, when installed outdoors, the
effects of the climatic conditions.
English