Burkert Type 8041 - Manual (Page 48)

46
Adjustmentandcommissioning
Notation convention: .....
Green LED state
Red LED state
NO
YES
See general con-
figuration diagram,
chap. 9.3 Device in Read mode?
.....
to view time delay before switching
1 2 3 4 5 6 7 8 910
0 s 100 s
Bargraph shows current time delay before switching, 52 s in
the example (by default = 100 s)
→
Press push button four times briefly
to set the factors of ten for the seconds of the time delay
before switching
→
Press and hold the push button
After 2 s, device is in Parameterizing mode:
A
Fig. 44: Setting the time delay before relay switching, part 1
If time delay before switching set to 52 s, LED
no. 6 flashes 9 times then stays on
A
Next LEDs come on one after the other
B
→
Press and hold the push button
→
Release push button when LED has flashed
the desired number of times
After 2 s, next LED flashes
1 flash = 1 s
→
Release the push button when desired
number of LEDs is on.
1 LED ON = 10 s
to set the seconds of the time delay before
switching
C D
Fig. 45: Setting the time delay before relay switching, part 2
English
Type 8041