Clear-Com Eclipse-Omega - Manual (Page 42)

Clear-Com
Eclipse Omega Instruction Manual
2 - 2 2
Figure 2-6: CPU Card’s Rear-Connector Panel
GPI-RLY INTERFACE CONNECTOR
The RJ-45 socket labeled “GPI/RLY Interface” connects the CPU card
to a GPI-6 or RLY-6 card. The GPI-6 provides six general-purpose
opto-isolated logic inputs. The RLY-6 card provides six single-pole,
double-throw relay outputs.
Both card types mount in either an IMF-3 interface frame or an
IMF-102 interface frame. Up to ten GPI-6 or RLY-6 cards can be
operated at one time from the matrix by daisy-chaining the cards
together. Each card has an IN and an OUT connector for this purpose.
The RLY-6 and GPI-6 cards connect to the GPI/RLY interface
connector using shielded category-5 cable. For more information about
the GPI-6 and RLY-6 cards, consult their respective manuals in the
Eclipse Omega manual set.
Note: If this port is used a ferrite must be added to the socket end
of each cable. A suitable ferrite is Würth Electronik part:
74271132.
1
2 3
4 5
6
7
GPI/RLY Interface Connector
(RJ-45)
Alarm I/O Connector
(female 9-pin D-type)
General Purpose Inputs Connector
(female 25-pin D-type)
LAN 1 Connector (RJ-45)
LAN 2 Connector (RJ-45)
RS-232 Connector (male 9-pin D-type)
General Purpose Outputs Connector
(male 25-pin D-type)
1