Clear-Com Concert for Newsroom - Manual (Page 29)

29 Concert Client User Guide for Mac
3 Using the Intercom Panel
This chapter describes how to use the Concert Client Intercom Panel.
The Intercom Panel is designed to enable communication with both Concert and Clear-Com Eclipse ™
users through a single interface. The virtual interface is modeled on an Eclipse V-Series push-button
panel.
Eclipse access parameters are set in the Concert Management Interface (CMI) by your system
administrator. To see if your system can access Eclipse, select
Preferences [ ] > Server [ ] > Advanced.
Even if your system is not enabled for Eclipse, you can still use the Intercom Panel to manage your
Concert calls, conferences and channels
For more information about Eclipse and Eclipse V-Series panels (including datasheets and manuals),
see
www.clearcom.com .
3.1 Opening the Intercom Panel
By default, the Intercom Panel is not displayed when the Client starts.
To open the Intercom Panel, do either of the following:

In the Concert menu bar, select Config > Intercom Mode.

In the Client console, click the Intercom mode icon [ ].
Note :
You cannot close the Intercom Panel by clicking the Intercom mode icon again [ ]. The other
principal function of the Intercom icon is to display the Intercom Panel above other windows.
To close the Intercom Panel from the Concert menu bar, select Config and
uncheck Intercom Mode.
In Intercom mode, both the Client console and the Intercom Panel are displayed.
If an Eclipse connection has been configured for you by the system administrator, Concert attempts to
establish that connection.
Note :
To view Eclipse access parameters, select Preferences (configuration) [ ] > Server [ ] >
Advanced.
Eclipse access parameters are not configurable from the Client. To enable Eclipse access, see your
system administrator.
Tip: To return to (open) the Concert Client console, click the Client icon [ ].