Clear-Com Concert for Newsroom - Manual (Page 32)

32 Concert Client User Guide for Mac
3.2.2 Configuring settings
To configure settings for the panel (and the Client console), click the Preferences (configuration) icon
[ ].
Tip: You can also access the Preferences dialog by right-clicking the audio test icon [ ] and
selecting Configure audio devices. The Preferences > Devices dialog is displayed.
For more information about configuring the Client, see 1 Setting up the Client.
3.2.3 Testing the audio device
To test the currently enabled audio device:
1. In the Intercom Panel, do either of the following:

Click the audio test icon [ ].

Right-click the audio test icon [ ], and select Perform Audio Test from the menu.
Note:
The audio test menu also shows the names of the audio devices
being tested.
2. To verify that your audio devices are configured properly, speak into the mic (audio input
device).
3. To stop the test, click the audio test icon (active mode) [ ] again. If you do not stop the
test, the test ends automatically after 30 seconds.
For more information about testing the audio devices in the Client, see
Error! Reference source not found. Error! Reference source not found..
3.2.4 Configuring Audio Feed
The Audio Feed facility [ ] enables you to monitor a continuous audio source (a listen-only
program feed) within Concert. Audio Feed are available from both the Client console and the
Intercom Panel.
To find out how to configure Audio Feed, see 1.9 Configuring Audio Feed [ ]
3.2.5 Controlling the volume
To adjust the volume on the Intercom Panel, use the volume slide control [ ] to the right of the
Intercom Panel screen.