Clear-Com Concert for Newsroom - Manual (Page 7)

7 Concert Client User Guide for Mac
3. To save the configuration, click Save.
Note:
If you are running Concert for the first time, the Server dialog does not close when you
click Save if you:

Do not set the server address (leave the field blank).

Enter an invalid server address.
To exit the Server dialog, you must either enter a valid server address or click Cancel.
1.3.1 Eclipse settings
The Advanced dialog also displays access parameters for Eclipse, the digital matrix system
from Clear-Com. These parameters cannot be edited. Eclipse parameters are set in the
Concert Management Interface (CMI) by your system administrator.
If you are enabled for Eclipse, you can alter your network settings for the Eclipse Network in
Preferences [ ] > Audio [ ] > Simple Mode.
The default is to obtain the Eclipse Network from the server.
For more information, see 1.7 Configuring the Audio settings.
1.4 Configuring the audio devices [ ]
To use Concert, you must configure the audio devices (input and output) on the Client.
To configure the audio input and output devices on the Client:
1. Do any of the following:

From the Concert menu bar, select Concert > Preferences. In the
Preferences dialog, select Devices [ ].

In the Client console, click the Preferences (configuration) icon [ ]. In the
Preferences dialog, select Devices [ ].

At the bottom right of the Client console, click Check Devices [ ]. Click
the Preferences (configuration) icon [ ]. The Devices dialog [ ] is
displayed.
Note:
When you start Concert for the first time, the Devices dialog is displayed automatically.
2. In Sound device, select the input audio device [ ] from the list.
To ensure that the input device is selected by default the next time you start Concert,
click Preferred [ ].