CNB ID2810PVF - Manual (Page 12)

XNET Network Dome Camera User’s Guide
Frame Rate
The number of frames to be
transmitted per second.
Video Rate
Bandwidth assigned for video
transmitted from XNET.
number of simultaneous
users. Set the value smaller
than, or equal to calculated
Max value displayed
User
Admin &
Time
Setup
Administrator
name &
password
For security reasons, CNBTEC
recommends changing these
values from the factory default.
Default value
User name : root
Password : dw2001
User
Admin &
Time
Setup
Current Time
Input correct time in this field.
Default value :
2001/1/1
⑥ Connecting input and output signals to the XNET.
Connectors Function Signal description Number
Mic/LINE-In Audio in
Connect microphone or output from audio
devices.
1
Line Out
Audio out for
speaker
Audio from remote site is available from
this connector in bi-directional audio
mode. Connect an amplified speaker, or
PA device.
1
Alarm Sensor Contact sensor, or Other Aux. Sensor 1
Sensor In
/Relay Out
Alarm annunciating
device, Aux Relay
Siren, Flashing Light, Relay for Access
control device…
1
100Base-T Network connection
Connect XNET to the network, LAN, ADSL
or Cable modem.
1
DC Power Input DC Power to network camera 1
⑦ Remote video connection to XNET
Before attempting to connect and view video from the XNET, install XNET-NVR to
the PC. This will automatically install the ActiveX component needed for a direct
connection with IE Explorer. For more detailed information on using “
XNET-NVR ” see the
XNET-NVR User Guide .
12 of 44