CNB ID2810PVF - Manual (Page 36)

XNET Network Dome Camera User’s Guide
Refer to [6.4. How To Upgrade Your XNET/XNET-
Wireless System].
Bootloader
Upgrade
Upgrade the bootloader installed in the network camera via
the network. Bootloader needed for the upgrade can be
downloaded from cnbtec’s home page.
Refer to [6.4. How To Upgrade Your XNET/XNET-
Wireless System].
Add PTZ File
Add a new PT driver software via the network. PT driver
can be downloaded from cnbtec’s home page.
Refer to [6.4. How To Upgrade Your XNET/XNET-
Wireless System].
Factory
Default
Setting
Re-initialize the network camera to factory default state.
By checking on a Radio button “Except Network
Configuration”, you can preserve the parameters for the
network. Checking on “All”, will return all the parameters to
factory default state.
Once XNET/XNET-Wireless is re-initialized as factory
default state, it should be set-up again using IP-
Installer.
System Reset
Perform remote reset by clicking the “CONFIRM” button.
All previous connections will be disconnected upon
reset. XNET/XNET-Wireless does not resume the
connections and the users must re-connect to the
server manually.
36 of 44