CNB ID2810PVF - Manual (Page 2)

XNET Network Dome Camera User’s Guide
This product is designed for indoor use only. When using this camera at outdoors or in an
environment that exceeds the limited range, you must separately use a water-resistant case.
Be careful not to cause any physical damage by dropping or throwing the unit. Especially keep
the device out of reach from children.
Do not disassemble this camera. You will be excluded from After Service when disassembled.
Use only the power adapter provided with this product.
If you would like to use this camera for security, monitoring, please check the legal
regulations within the country.
Directions
z Consult the dealer or an experienced radio/TV technician for help.
z Connect the equipment into and outlet on a circuit different from that to which
the receiver is connected
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generate, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Note
Any changes or modifications in construction of this device which are not explicitly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
This appliance and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter. A minimum separation distance of 20 cm must be
maintained between the antenna and the person for this appliance to satisfy the RF
exposure requirements.
Caution
2 of 44