CNB ID2810PVF - Manual (Page 24)

XNET Network Dome Camera User’s Guide
Administrator
Confirm
Password
Enter the password once more to confirm the password.
Add User
Username
Enter the user ID you want to add. Up to 100 users are
supported by XNET/XNET-Wireless.
Add User
Password
Enter the user password.
You can set different system resource access capabilities for
each of the users. Attributes are Audio, Bi-directional Audio
and Pan/Tilt control. For example, if you want a specified
user to hear the audio from the XNET/XNET-Wireless, check
Audio in the check box.
Add User
Attribute
User List
You can list “user ids” and “ their attributes” here.
format : user id[A, BA, P] :
A – audio,
B – bi-directional audio,
P – ptz(Pan/Tilt), not used for this model.
You can delete specific user by clicking the DELETE button.
YES
SAVE
If you want to restrict viewing access to the XNET/XNET-
Wireless, check at the box left to Yes and click on Save.
Users need to input ID and password to connect to
XNET/XNET-Wireless. The a pop up window as shown below..
Figure 5-6. User authentication pop up
If the username or password are incorrect, an error message
will be displayed
Authentication
for Viewing
If no, default
attribute
If you uncheck for the Authentication for Viewing, all users
can access the XNET/XNET-Wireless with the same attribute
set here. Checked attributes are enabled. Click “Save” to
save the attribute.
Time Setup Current Time It shows you the current time of XNET/XNET-Wireless.
24 of 44