CNB ID2810PVF - Manual (Page 32)

XNET Network Dome Camera User’s Guide
Note that zoom is not applicable for XNET
PTZ
Operation
Check
You can check the various operation of the PT devices.
z “ Left ”/”Right”/”UP”/”DOWN”
z ZIN(Zoom In), AUTOFOCUS, ZOUT(Zoom Out)
functions does not applicable to this product
You can set up the PTZ limitation & preset positions if the PT
device supports it.
Panning
Limitation
Set the left/right limitation and test.
Select Left/Right position before setting.
Panning
Limitation
RESET
Clear the panning limitation previously set.
The panning range will be the same as the PT device allows.
Panning
Limitation
SET
Set the present position as left or right panning limitation.
Panning
Limitation
TEST
Test the panning limitation which was set previously.
Preset
Position
Set the preset position and test.
Preset
Position
Preset &
Move
Select a preset position to move to. Movement to the preset
position will be made upon clicking on “MOVE”
Preset
Position
Name Set
Assign logical name for the preset position. Enter into the field
and click on SET.
PTZ Position
Setup
Preset
Position
Set
Set the present position as a preset position with position
number shown at the right of “Preset & Move” and name
shown at the right of “Name Set”.
<Note> : “PTZ Position Setup” feature is applicable only for the PT devices that support it.
32 of 44