CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 10)

TSAM Installation and Maintenance Rev. 2.10 Chapter 1
CTI Products, Inc. System Description
2
• A transmitter may be manually selected via a "force" override.
• Optional Secondary Mode operation, which removes a single base station
site from the voting scheme and locks it on an alternate frequency, using
internally generated frequency select tones. Audio is automatically routed
to a secondary base station interface.
• Two tone generators, one for main and one for secondary mode operation.
• A number of key operational parameters are field programmable.
• PTT relay outputs for both Main and Secondary channels.
• Repeater Operation
1.2 Model Description
Two basic model numbers exist for the TSAM units:
• S1-60165-xxx TSAM -- 8 Transmitters -- No Secondary
This unit has just the Transmit Control Board.
• S1-60006-xxx TSAM -- 8 Transmitters -- With Secondary
This unit has the Transmit Control Board
and the Receive (secondary) control board.
1.3 Accessories
The following accessories are available as separate line items for the TSAM unit:
Part Number Description
31-10354 Punch Block, Dual 25 Pair
S1-60216 Cable Assy Tel 50 Pin Female to Male 25FT
(1) req'd for each Non-Secondary TSAM unit. (2) for each Secondary unit
81-10397 POWER SUPPLY 120VAC TO 20 VAC TSAM
(1 req'd for each TSAM unit).
S2-60740 TSAM Diode Matrix Plug (50 pin - 25 diodes)
S1-60838 Expansion cable kit (2 TSAMs Total)
S1-60839 Expansion cable kit (3 TSAMs Total)
S1-60840 Expansion cable kit (4 TSAMs Total)
S1-60841 Expansion cable kit (5 TSAMs Total)
S1-60842 Expansion cable kit (6 TSAMs Total)
S1-60843 Expansion cable kit (7 TSAMs Total)
S1-60844 Expansion cable kit (8 TSAMs Total)
Table 1 TSAM Accessories