CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 50)

TSAM Installation and Maintenance Rev. 2.10 Chapter 5
CTI Products, Inc. Setting Programmable Options
42
5.5.2.2 Coded / Clear using Single Function Tone Keying
Works with Main (Steered) system only.
The TSAM can be programmed to control the Coded or Clear TX in a base station on the Main (steered)
system with a single function tone (versus the dual function tone PMC).
This control tone is controlled by the Console 1 Coded/Clear signal as shown below:
TX State
Console 1
Coded/Clear Function Tone Sent
Clear High F1 as programmed in Function Tones
Coded Low Coded Key FT as programmed below
To program the Single Tone Coded Keying tone, answer S and enter the tone desired for Coded mode as
shown:
Select Coded (Encrypted) TX operation:
P Positive Mode Control (PMC - Dual function tone)
Supports Main & Secondary
S Single Function Tone Coded Control
Supports Main Only
F1=Clear Keying; FCoded=Coded Keying
N No Coded Support
(P/S/N)? --> (N) N : S
Clear Keying is Standard F1
Coded Key FT (Hz) = (1150) 1150 : 1150
5.5.3 Keyup Function Tones
The TSAM supports up to 16 channel base stations. F1 is always the Main steered channel. Whenever the
Main channel is keyed, the F1 Function tone is used to key the base on F1 (unless Coded Single Tone
Keying is used). In secondary operation, Function tones 2-16 are used. This allows 15 different secondary
channels to be supported by the TSAM. The function values are programmable from 0 Hz to 5000 Hz,
with 0 Hz being a muted tone.
See Section 4.11, Secondary Frequency Tone Table, for more details on how F1-F16 are controlled.
5.6 Repeater Options
Repeater options are programmed from the Repeater menu.
:R
Repeater Keying Options:
To accept (DEFAULT) value: type <d> or <D>.
To accept CURRENT value: type <return>.
To change: type desired value then <return>.
Enable repeater operation (Y/N) = (N) Y : Y
Enable TSAM internal tone keying (Y/N) = (Y) Y : Y
Repeater Hang Time (msec) = (3000) 3000 : 3000
Resteer Key-up Delay Time (msec) = (0) 0 : 0
Finished.