CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 41)

TSAM Installation and Maintenance Rev. 2.10 Chapter 4
CTI Products, Inc. Installation
33
4.13 Front Panel Indicators
The TSAM has several front panel LED indictors used to display operational status and diagnostic
information.
Reset
This indicator lights when the reset line is held low. This LED should be lit when the front panel reset
button is pressed or the TSAM is initially powered.
Vote
The vote led indicates the start of the steering process. This LED is lit when a voted site is detected and the
Free Vote Time has expired. the vote has ended The LED remains lit until the Fade Hold time expires.
Active
This indicator is lit when the TSAM successfully powers up and initializes itself. The indicator should
always be lit. A problem exists if the indicator is not lit.
Master
This LED indicates when a TSAM is configured as a master unit (SW102-4 is up). Only one TSAM on a
steered channel can be a master, all other TSAMs must be slave units.