CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 29)

TSAM Installation and Maintenance Rev. 2.10 Chapter 4
CTI Products, Inc. Installation
21
4.2.3 Expansion Unit Programming
When a system is programmed for a slave (expansion) TSAM and the slave unit is disconnected, the
system must be reprogrammed to insure proper operation. If you must run a system with an expansion unit
disconnected, re-program the master TSAM for one less expansion unit. Be sure that the expansion units
are addressed sequentially.
4.3 Physical installation of TSAM
A set of rack mount ears are furnished with the TSAM. There are two mounting locations on the TSAM
enclosure for the mounting ears. There are two sets of mounting holes in the ears. The ears may be
mounted with the mounting flange forward or reversed. These options allow the TSAM to be mounted in
any of 8 positions. This allows mounting in a variety of racks or cabinets.
Figure 6 TSAM Mounting Positions