CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 58)

TSAM Installation and Maintenance Rev. 2.10 Chapter 5
CTI Products, Inc. Setting Programmable Options
50
5.7 Secondary Channel Options
Enter the Secondary Options menu with an “S” from the main menu.
5.7.1 Debounce Time
Selecting the secondary site and frequency may cause the TSAM control inputs to change several times
before the desired site and frequency are set, especially if the console uses a scrolling control. To avoid
extra tone control sequences being sent for each affected site and frequency, the TSAM waits for the
debounce time after seeing a site or frequency change. This give the operator and console equipment time
to settle on the final secondary site and frequency value selected.
The length of the debounce time is programmable from 0 to 32,767 msec. Times shorter than the control
tone sequence will not result in any faster operation, so setting the debounce time to less than the typical
tone sequence is of no value. The default value is 250 msec and is suitable for most applications. If the
frequency change function of the PMC tone sequence is not supported by the systems base stations, then
setting a longer debounce time is recommended. This reduces the chance of an unwanted base keyup as
the secondary site and frequency are selected.
:S
Secondary Options:
To accept (DEFAULT) value: type <d> or <D>.
To accept CURRENT value: type <return>.
To change: type desired value then <return>.
Site/Freq change debounce time (msec) = (250) 250 : 250
For consoles with non-scrolled controls, this parameter can be set down to 100 or possibly 50
milliseconds.
5.7.2 PL Monitor Menu
Unit Versions 1.70 and up / Secondary System Only
Enable PL Monitor Function (Y/N)? --> : Y
Select PL Monitor Mode
M - Momentary (Monitor until next transmission)
S - Sustained (Remonitor after each transmission)
(M/S)? -->(M) M : M
PL Monitor Tone (Hz) = (2050) 2050 : 2050
PL Monitor delay (msec) = (100) 100 : 100
Select Momentary or Sustained PL Monitor Mode from the menu. See section 3.4, Secondary Channel
PL Monitor Control for more details on this option.
Program the PL Monitor Tone.
Program the PL Monitor Delay Time.