CTI Products TSAM Transmitter Steering & Audio Matrix - Manual (Page 54)

TSAM Installation and Maintenance Rev. 2.10 Chapter 5
CTI Products, Inc. Setting Programmable Options
46
5.6.4 EI: Enabling Individual transmitters for multicast
Use the EI command to enable individual transmitters for multicast. The EI command lets you enter a
number of transmitters if you wish. End each entry with a <CR> (<Enter>). When you are finished
adding transmitters, enter a 0 <CR> for the transmitter number. You can see the results with the L (List)
command.
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: EI
Enter Transmitter Number (1-64) to Enable
(1-64, or 0 to Quit)? --> : 1
(1-64, or 0 to Quit)? --> : 2
(1-64, or 0 to Quit)? --> : 3
(1-64, or 0 to Quit)? --> : 6
(1-64, or 0 to Quit)? --> : 7
(1-64, or 0 to Quit)? --> : 8
(1-64, or 0 to Quit)? --> : 0
Edit Multicast Transmitter Selection
EA Enable All Transmitters
EI Enable Individual Transmitters by TX number
DA Disable All Transmitters
DI Disable Individual Transmitters by TX number
L List Enabled Transmitters
Q Quit Multicast Selection
(EA/EI/DA/DI/L/Q)? -->
: L
TSAM(1) Y TX: 1 2 3 __ __ 6 7 8
TSAM(2) N TX: __ __ __ __ __ __ __ __
TSAM(3) N TX: __ __ __ __ __ __ __ __
TSAM(4) N TX: __ __ __ __ __ __ __ __
TSAM(5) N TX: __ __ __ __ __ __ __ __
TSAM(6) N TX: __ __ __ __ __ __ __ __
TSAM(7) N TX: __ __ __ __ __ __ __ __
TSAM(8) N TX: __ __ __ __ __ __ __ __
Note that the EI command works with the currently enabled transmitters. In this case we happened to start
with no transmitters enabled.