Aastra Telecom SISIP 57I CT - Manual (Page 207)

Operational Features
41-001160-00, Rev 01 Release 2.0 5-79
Operational IP Phone Features
Operational IP Phone Features Model 53i Examples
Use the following procedure to configure the Park/Pickup call feature using the
programmable configuration method and the configuration files.
Programmable Configuration Using the Aastra Web UI
On the 57i/57i CT, you configure a Park and/or Pickup key at
Operation->Softkeys and XML. You enter a key label, and value for a specific
line on the phone. The default state of the Park configuration is "connected". The
default state of the Pickup configuration is "idle, outgoing".
The 57i CT handsets use the park/pickup configuration enabled at
Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled
on more than one line on the base unit, the 57i handset uses the first
programmable configuration.
Server Park Configuration Pickup Configuration
Asterisk prgkeyN type: park
prgkeyN value: asterisk;70
prgkeyN line: 1 prgkeyN type: pickup
prgkeyN value: asterisk;70
prgkeyN line: 1
Sylantro prgkeyN type: park
prgkeyN value: sylantro;*98
prgkeyN line: 1 prgkeyN type: pickup
prgkeyN value: sylantro;*99
prgkeyN line: 1
BroadWorks prgkeyN type: park
prgkeyN value: broadworks;*68
prgkeyN line: 1 prgkeyN type: pickup
prgkeyN value: broadworks;*88
prgkeyN line: 1
ININ PBX prgkeyN type: park
prgkeyN value: inin;callpark
prgkeyN line: 1 prgkeyN type: pickup
prgkeyN value: inin;pickup
prgkeyN line: 1
Note: The 53i does not allow for the configuration of labels and states.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
“Softkey Settings for 55i, 57i, 57i CT” on page A-110 and “Programmable Key Settings for 53i and 55i” on
page A-117.