Aastra Telecom SISIP 57I CT - Manual (Page 47)

Administrator Level Options
41-001160-00, Rev 01 Release 2.0 3-7
Administrator Options
Administrator Options • Network Port 1 (53i)
Displays the IP address on Port 1 of the phone.
• Network Port 2 (53i)
Displays the IP address on Port 2 of the phone.
• Network Status (55i, 57i, and 57i CT)
Displays the network status of the Ethernet ports at the back of the phone. You
can also view the phone’s IP and MAC addresses. These fields are read-only.
• Firmware Version
Displays information about the firmware that is currently installed on the IP
phone.
• Restart Phone
This option lets you reboot the phone. A reset may be necessary when:
- There is a change in your network, OR
- To re-load modified configuration files, OR
- If the settings for the IP phone on the IP PBX system have been modified.
• Restore Defaults (53i) or Factory Default (55i, 57i, 57i CT) (admin only)
This option lets you reset the phone to its factory default settings. There are
two options in setting the factory defaults on the IP phone:
-All Defaults
-Config Default
The "All Defaults" option resets the factory defaults for all of the settings in
the aastra.cfg, <mac>.cfg, and local configuration. Performing this option
results in losing all user-modified settings.
The "Config Default" option resets the settings on the local IP phone
configuration only.