Configuring the sip local dial plan, Operational ip phone features – Aastra Telecom SISIP 57I CT User Manual
Page 268
Operational Features
5-140
41-001160-00, Rev 01 Release 2.0
IP Phone Administrator Guide
Operational IP Phone Features
Configuring the SIP Local Dial Plan
Use the following procedures to configure the SIP Local Dial Plan using the
configuration files or the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
on
Aastra Web UI
1
Click on Basic Settings->Preferences.
2
In the "Local Dial Plan" field, enter a valid local dial plan (up to 127 alphanumeric characters) for the
IP phone. Default is X+#|XX+*. Enter prepended digits as required.
3
Enable the "Send Dial Plan Terminator" field by checking the check box. (Disable this field by
unchecking the box). Default is disabled.
4
In the "Digit Timeout (in seconds)" field, enter a timeout value. This is the length of time the phone
waits before dialing. Default is 4 seconds.