Aastra Telecom SISIP 57I CT - Manual (Page 76)

Full-Duplex (10Mbps or 100Mbps)
Full-duplex data transmission means that data can be transmitted in both
directions on a signal carrier at the same time. For example, on a LAN with a
technology that has full-duplex transmission, one device can be sending data on
the line while another device is receiving data. Full-duplex transmission implies a
bidirectional line (one that can move data in both directions). On the IP phones,
you can set the full-duplex transmission to transmit in 10Mbps or in 100Mbps.
Configuring Ethernet Ports 0 and 1
You can configure the Ethernet port transmission method to use on the IP phones
using the configuration files, the IP Phone UI, or the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Network
Settings” on page A-5.
IP Phone UI
Step Action
1 Press on the phone to enter the Options List.
2 Select Ethernet.
3 Select Phone (for Ethernet Port 0).
4 Select a negotiation method to use on port 0 and press Set. Valid values are:
•
AutoNegotiation
• FullDuplex 10Mbps
• FullDuplex 100Mbps
• HalfDuplex 10Mbps
• HalfDuplex 100Mbps
Default is FullDuplex 10Mbps.
5 Select Passthrough (for Ethernet Port 1).