Perma Pure RATAMATION V2.0 - Manual (Page 11)

RATAmation v2.0 User Manual Perma Pure LLC
Phone (732) 244-0010
www.permapure.com
Sept. 2012 9
The Run screen (Figure 6) is used to collect data for run. The screen contains one grid with a
column for each analyzer and other analog inputs. Only items that have been configured in the
‘Analog Input Configuration’ screen will be displayed in this test screen. The visible items on the
screen are adjusted in size to fill the available space in the Test Panel.
Figure 6
When the Run screen is initally displayed the program assumes that cal gas has just begun
flowing so there is a built in delay equal to the System Response Time to allow the analyzers to
stabilize. In Manual mode the operator will control the start of the run. In Automatic mode the
computer will start the run immediately following the System Response Time delay. The top line
of the grid will display “No Run End Sample Selected” at the top with 15 second average
readings adding just below “No Run End Sample Selected”. The newest reading is at the top of
the list. The program will collect readings for the time period specified in the ‘Program Set Up’
screen. In Manual mode the operator will select the end point for the run (the end point is used to
determine the readings used to calculate the run average.) In Automatic mode the computer will
record the last reading after a specified period of time.