Ratamation v2.0 user manual perma pure llc – Perma Pure RATAMATION V2.0 User Manual
Page 57
RATAmation v2.0 User Manual
Perma Pure LLC
Phone (732) 244-0010
www.permapure.com
Sept. 2012
55
f. Connect an Ethernet cable directly between the 4300 FCD and the computer. Power must
be on for the FCD.
g. Go to Start, select AutomationDirect Tools, select NetEdit 3.
h. Click on the Scan Network button at the top. A line of data will fill the top line
indicating connection to the FCD.
i. Right click on the top line. A menu will open. Select General. There are two selection
points. Select Use the following IP address: Notice that the IP address and Default
Gateway addresses are swapped as compared to the computer settings.
i. Enter the IP Address as
192.168.135.9
ii. Enter the Subnet Mask as
255.255.255.0
iii. Enter the Default Gateway as 192.168.135.10
j. Click OK to exit.
k. Turn off power to the FCD. Connect both the computer and the FCD to the network. Turn
on power to the FCD and restart the computer.
3. Configure RATAmation program
a. Open RATAmation.
b. Open the Configuration menu at the top. Select Communications. The words Test Key
should be grayed out indicating that the program is seeing the Crypto-Key. If the
lettering is black, click on it and a window should open saying the program is
unlocked.
c. Open Configuration again and select Communications. Clicking on this will open a
window. If necessary click on Retest and Reload List and then Open and Test. If the
configuration was successful, it will say 4300 Communications OK. Click Exit.
d. In the lower left of the window you should see LIVE DATA. This indicates that the FCD
and the computer are communicating properly.