Bosch MUMXL10T Kitchen machine MaxxiMUM - Manual (Page 24)

24 Robert Bosch Hausgeräte GmbH
Tip: After processing liquids, it is often suffi-
cient to clean the blender without removing
it from the appliance. Pour a little water and
washing-up liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse
out the blender with clear water.
Troubleshooting
The multi-function arm must be engaged
in each operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action

Check the power supply.

Check the mains plug.
 Check multi-function arm.
Correct position? Engaged?

Screw on bowl all the way.

Attach drive cover to unused drives.

The safety lock is active.
Switch appliance to 0/off and then back
to the required setting.
Fault
Appliance switches off during use.
The overload protection feature has been
activated. Too much food was processed
at one time.
Remedial action

Switch off the appliance and pull out the
mains plug.

Leave the appliance to cool down
for 15 minutes in order to deactivate
the overload protection.

Reduce processing quantity.
Do not exceed permitted maximum
quantities (see “Application examples”).

Switch on appliance again.
If the motor still does not start, leave
the appliance to cool down for a longer
period (at least 1 hour).
Fault
While the drive was running, the release
button was inadvertently pressed.
The multi-function arm moves up.
The drive switches off, but does not stop
in the tool change position.
Remedial action
 Set the rotary switch to 0/off.

Move multi-function arm to posi-
tion 2.

Switch on appliance (setting 1).
 Switch off appliance again.
Tool stops in tool change position.
Fault
Blender does not start working or stops
during use, the drive is “humming”.
Blade is blocked.
Remedial action

Switch off the appliance and pull
out the mains plug.

Detach the blender and remove
the obstruction.
 Re-attach the blender.
 Switch on the appliance.
Application examples
Whipped cream
200 g–1500 g

Whip cream with the whisk for
1½ to 4 minutes at setting 7
(depending on the quantity and
properties of the cream).

Follow instructions in the section
“Important information for using the
whisk” for adjusting the appliance
to the amounts to be processed!
Egg white
2 to 12 egg whites

Beat egg white with the whisk
for 2 to 6 minutes at setting 7.
 Follow instructions in the section
“Important information for using the
whisk” for adjusting the appliance
to the amounts to be processed!
en
Risk of injury!
Before eliminating a fault, pull out the
mains plug.
Important information
If the fault cannot be eliminated, please
contact customer service.