Teledyne 9060L - Zirconium oxide flue gas oxygen analyzer User Manual
Page 14
Advertising
Introduction Model
9060L
Teledyne Analytical Instruments
14
Figure 1-2 Rear Panel
• Power Connection 110 VAC at 50/60 Hz. The connector
housing includes the fuse holder and the
power switch. (220VAC is optional via
setting an internal switch).
Fuse Holder: Replacing the fuse is
described in Chapter 5, Maintenance.
I/O Power Switch: Turns the instrument
power ON (1) or OFF (0).
• Analog Outputs
0–10 VDC concentration output.
0–10 VDC range ID (or optional
overrange) output.
4–20 mA DC concentration output,
negative ground.
• Alarm Connections Alarm 1 (HI alarm), Alarm 2 (LO alarm),
and Probe Failure Alarm connections.
• Sensor Connector For connecting the probe’s Oxygen
sensor.
• Heater Connector For connecting the probe’s heater
Advertising