Teledyne 9060L - Zirconium oxide flue gas oxygen analyzer - Manual (Page 42)

Maintenance Model 9060L
Teledyne Analytical Instruments 42
3. Insert a small flat-blade screwdriver into the slot in the receptacle
wall nearest the fuse and gently pry open the fuse receptacle. The
fuse holder will slide out. There are two fuses in use and are
visible in the clip.
4. Remove the bad fuse and replace it with a 5x20mm 2A,
250 VAC, IEC time lag (T) fuse (P /N F1296).
5. Replace the fuse holder into its receptacle, pushing in firmly
until it clicks.