Reese 37152 MULTI-FIT RECEIVER User Manual

Installation instructions, Small pickup multi-fit, Product no

Advertising
background image

CENTER SECTION ASSEMBLY

GENERAL INSTRUCTIONS:

1. Insert side plate assemblies into hitch center section. Refer to specific instructions for proper bolt location.
Insert the coiled end of fishwire through proper hole on rear side of center section and through access hole in
plate. Attach 1/4” bolt plate and 1/2 x 1-1/4 lg. carriage bolt as shown above. Pull fasteners through and loosely
install 1/2 hex lock nut. Repeat steps for each fastener. The spare tire may need to be lowered to install the hitch
center section. It will be replaced later.
2. Refer to the application chart to determine the correct installation for your vehicle. (Last page of each language)

FOR ALL INSTALLATIONS:

1. Torque all 3/8" nuts to 35 lb.ft. 5. Torque all 10mm CL10.9 hardware to 53 lb.ft.
2. Torque all 12mm nuts & bolts to 65 lb.ft. 6. Torque all 10mm Torx hardware to 60 lb.ft.
3. Torque all 7/16” hardware to 50 lb.ft. 7. Torque all 5/8” hardware to 100 lb.ft.
4. Torque all 1/2” hardware to 75 lb.ft. 8. Retighten the spare tire if it was loosened.

NOTE: Not all of the hardware will be used in every installation. Paint any bare metal to prevent rust.

TOOLS REQUIRED

3/4” SOCKET & WRENCH
11/16” SOCKET & WRENCH
9/16” SOCKET & WRENCH
15MM, 17MM SOCKET
18MM, 19MM SOCKET
21MM, 22MM SOCKET
TORQUE WRENCH
SAFETY GLASSES
TORX T50 WRENCH

SIDE PLATE ASSEMBLY

SEE SPECIFIC INSTRUCTIONS
FOR PROPER BOLT LOCATION

MUST INSTALL REAR SIDE BOLT FIRST

1/2” x 1.25 LG. CARRIAGE BOLT

1/4 x 1 x 2” BOLT PLATE

1/2 HEX LOCKNUT

ACCESS
HOLE

For Installation Assistance or Technical Help, Call 1-800-428-7303

TOP VIEW HITCH

FRONT BOLT IS
OUTBOARD ONE HOLE

ALL (4) BOLTS ARE REQUIRED

APPLY SPECIAL LOAD RATING
LABEL (110990)

PULL WIRE
(SUPPLIED)

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

INSTALLATION INSTRUCTIONS

Product No.

37152

SMALL PARTS
PACKAGE 37620

IMPORTANT NOTES

USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH

SMALL PICKUP

MULTI-FIT

You can take it with you.

PLYMOUTH, MICHIGAN

37152IN_C 04-05-06 PCN08678 © 2006 Cequent Towing Products

Litho in USA

Advertising