Reese 37152 MULTI-FIT RECEIVER - Manual (Page 10)

INSTALLATION H
1/2” FLAT WASHER
1/2” LOCK WASHER
1/2” HEX NUT
1/2” THICK SPACER
WHEN NEEDED
DRILLED HOLE
TOOLS REQUIRED
3/4"(19MM) SOCKET
19MM SOCKET
1/2" DRILL
TORQUE WRENCH
SAFETY GLASSES
VEHICLE FRAME
BUMPER
BRACKET
1/2” LOCK WASHER
12mm HEX NUT
USE THIS HOLE
FOR NISSAN FRONTIER
CENTER SECTION ASSEMBLY
1/2” FLAT WASHER
1/2” LOCK WASHER
12mm HEX NUT
12mm X 1.75 X 40mm
HEX BOLT
1/2” LOCK WASHER
12mm HEX NUT
1/2 x 2” CARRIAGE BOLT
1/4” X 1-1/2” X 3”
BOLT PLATE
-L -
BRACKET
1/2” FLAT WASHER
HOLE 3
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
87-04 NISSAN PICK-UP / FRONTIER 2 & 4 DOOR WITH 75” BEDS
1. Remove the bolt from the bottom of the frame, reverse its direction, and reinstall the bolt with the head on the bottom
of the frame. Position the side brackets up to the frame rearward of the bolt with a 1/2” spacer over hole 3.
2. Drill a 1/2” hole in the frame at hole 3. Install a 1/2” carriage bolt with 1/4 x 1-1/2 x 3” block down through the frame,
spacer and hole 3.
3. Attach the “L” brackets to the side brackets over holes 1 & 2 with two (2) M12 x 40mm hex bolts as shown.
4. Using the long slot as a guide, drill a 1/2” hole at far end of slot through the bumper brackets. Install M12 x 40mm
hex bolts, flat washer, lock washers and nuts on the bolts.
5. Install center section per SIDE BRACKET LOCATION 2. (See page 2.)
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE