SKC DatraTrac 2000 for the AirChek 2000_3000 - Manual (Page 23)

21
Cut Button
To clear the selected (highlighted) program from the AirChek 2000/3000 Scheduler
and place it into the Program Edit Bar, click on the Cut butt on (Figure 18). A program
can also be cut by double-clicking the program number or the line number to the
left of the rate column of the scheduler (Figure 16).
Before sending a program to the pump by clicking the ToPump butt on, it is
important to set the Run Time Options in the Options menu under Pump Sett ings
(see SKC Pump Program Sett ings window, page 26). It is also important to clear
the history either in the Run Time Options menu or in the Tools menu.
ToPump Button
To write the Pump Program Schedule to the pump,
click the ToPump butt on (Figure 18). A DataTrac 2000
dialog box will appear (Figure 19).
Click OK to send the program to the pump. A
“Program Loaded” dialog box (Figure 20) will appear
on screen to verify the operation.
Writing a program to the pump will cause the PROG
icon to appear on the pump LCD, which will remain
active until all programs are completed.
Edit a Program
To edit a program displayed in the Pump Program Scheduler, double-click on it.
This will remove it from the Pump Program Scheduler and place it in the Program
Edit Bar. Any program already in the Program Edit Bar will be erased.
FromPump Button
To display a Pump Program Schedule from a previously programmed pump, click
on the FromPump butt on (Figure 18).
Time Bump Buttons
To increase or decrease all program start and stop times in the Pump Program
Scheduler, click on the Time Bump butt ons (Figure 29).
Save a Program
To save the Pump Program Scheduler to a PC as a program fi le (.pgm), select the
Save command from the File menu.
The default extension .pgm is used to indicate AirChek 2000/3000 Scheduler fi les.
Figure 20. Dialog Box
Figure 19. Dialog Box
SKC Pump Scheduler Window